JT's Stockroom C063: PES Power Box

C063	PES Power Box	249.00

This power source unit is designed to stimulate throughout the genital areas by creating a controlled energy current. The unit hooks up to any of our Erotic Electro Stimulation devices, which then deliver the energy through conductive electrodes touching the skin.

Erotic Electro Stimulation interacts directly with nerve endings instead of the limited surface stimulation of mechanical vibrators. The P.E.S. Power Box tunes in on the nerve endings, harmonizing with the body's own electrical impulses. After reaching a good power level, the frequency and pulse rates can be adjusted until the desired response is reached in the form of Erotic Electro Stimulation.

Physiologically speaking, when properly adjusted for power and frequency, PES'erotic electrical devices amplify natural electrical impulses at the nerve endings. Electro Stimulation increases the nerve impulses from low to high frequency levels, and result in an interplay with the normal response an effect that is totally unique and nothing like the sensations from mechanical vibrators. Electro Stimulation devices can merge or totally interface with electrical impulses to nerve endings; triggering arousal in excess of ones own normal orgasmic response. This intensification of the average sexual experience is an effect mechanical vibrators can't match.

*The PES Power Box can be used with up to four single or two double PES electrodes. Push-button switches allow for the momentary pause of any device, while LEDs visually show the frequency of the pulses. Adjustments include two POWER control knobs, a PULSE knob, and two FREQUENCY knobs, one on the face of the box and a fine adjustment on the side. The box comes with an A/C Adapter and two pair of low profile leads for attachment to the electrodes, and will also operate with a 9-volt alkaline battery (not included). Note: the 9-volt battery will not provide sufficient power to operate 2 PES Electro Stimulation devices concurrently.

*Overseas caution: PES Electro Stimulation boxes are designed to operate on a 9-volt alkaline battery or the supplied 110 volt A/C Adapter. For overseas locations, a converter can be used with the A/C Adapter or local adapter purchased that supplies 9-12 volts DC, 300-500 mA. The Adapter plug must be a center pole positive for the input plug for the box.

PES TECHNICAL INFORMATION:

The Low Profile Leads use pinch technology on snap electrodes attachments. This is a very lightweight lead that is compatible with all snap electrodes on P.E.S. products. The Low Profile Leads have spreader clasps which adjust the lead lengths. This is especially helpful when using more than one PES device at one time.

On/Off
This switch turns the Power Box on and off. The switch should be in the off position before inserting, applying, or removing electrodes.

Coarse Power Adjustment
This is the primary power adjustment. This knob and the Fine Power Knob should be on 1 when the box is turned on, and then increased as needed. ( in some configurations this knob may increase to 9 or 10 before the sensations are felt)

Fine Power Adjustment
This is the fine tune adjustment for the coarse power adjustment. It will increase the power at a slower rate.

Pulse Adjustment
This control knob adjusts the pulsations of the current and should be set at 10 before turning on the power. It produces a steady pulse when set at 10 and a very slow pulse when set on 1.

Coarse Frequency Adjustment
This control adjusts the frequency of the current and should be set at 10 when the box is turned on. It produces a sharper or softer feel of the current and is a very important feature in achieving a hands free ejaculation.

Fine Frequency Adjustment
This control is a "thumb wheel" found on the right hand side of the PES power box and is a critical part of the frequency adjustment.

LED Indicators
These indicator lights will illuminate when the power is on and will flash intermittently to the rate of the pulse.

Channel A & B Lead Connections
These connections are found at the top of the PES Power Box and is the location where the Low Profile leads connect.

Channel A & B Power Interrupts
These two push buttons found on the front of the PES Power Box interrupt the power sent to the electrodes when depressed and return the current flow when released. (note: the power control should be turned to 1 or the power box turned off before releasing the buttons.

THE TOYS IN THIS CATALOG ARE FOR USE BY CONSENTING ADULTS AS NOVELTIES, FASHION ACCESSORIES, AND SEXUAL TOYS.
JT's STOCKROOM ASSUMES NO RESPONSIBILITY FOR UNSAFE, IMPROPER, OR ILLEGAL USE OF THESE ITEMS.